Submitted by pblcom on Mon, 04/06/2015 - 09:48 Forums General Discussion Hi everyone! Is it possible to load the new data in a computing machine EMTP during the calculation? Thanks in advance. Ignat. e.rutovic Hi,It is not possible to Hi, It is not possible to change the model parameters during a simulation. However, since many devices can be controlled (Source, Impedance...). it is relatively easy to build complex cases. I hope it helps. Regards, Emmanuel. Log in or register to post comments Thu, 10/13/2016 - 16:14 Permalink Log in or register to post comments
e.rutovic Hi,It is not possible to Hi, It is not possible to change the model parameters during a simulation. However, since many devices can be controlled (Source, Impedance...). it is relatively easy to build complex cases. I hope it helps. Regards, Emmanuel. Log in or register to post comments Thu, 10/13/2016 - 16:14 Permalink
Hi,It is not possible to
Hi,
It is not possible to change the model parameters during a simulation. However, since many devices can be controlled (Source, Impedance...). it is relatively easy to build complex cases.
I hope it helps.
Regards,
Emmanuel.